Active remetallizer
RESURS MOTO. Manufacturer - VMPAUTO, St.-Petersburg,
Russia. Remetallizer’s dosage: one can per 1 l of the oil. Best
one between tested, increases engine resource at the
most.
Metal conditioner
FENOM. Manufacturer - company "Laboratory of the Tribo
Technology", Moscow, Russia. Metal conditioner’s dosage
- 1 ml per 1 l of the blended fuel. Suitable for engine of the land and
water moto technique. Takes first place as composition for running in of
the new engines. It is little bit worse then RESURS MOTO as
protection of the bearings and pump elements.
Four-ball tester. The steal small ball are packed
in the pyramid and dipped into the lubricant. They rotate relatively to
each other and gradually squeeze. The loading size is measured according
to what the lubricant squeezes almost completely from the contact zone and
the friction moment sharply increases.
|
...OR
WATER? On the market of the moto chemistry there are two
products of the “anti friction” which improve characteristics of the motor
oil "2Ò" (look photo). What do they promise? Resource of the new engine
will grow greatly, the used engine will have second youth: compression
will grow. It sounds impressive. However oil manufacturers think about
modification of their product very skeptic: it is unnecessary to add
anything to already good product. And also it is dangerous – oil may
become akin water. Who is right? We decided to appreciate the results of
the additive use by the laboratory methods and on the “live” engine. We
have bought chemistry, checked how do they work.
WITHOUT
GOLD
We have done tests on the
equipment approved by GOST 9490-75 and Ð 51176-98. First we tested how
remetallizers can be mixed with the oil. We choosed "Spectral" MGD-14” as
“laboratory animal”. We stired up the laboratory meterings of the
principal index lubricants. We have not found signs of the obvious motor
oil "damage" caused by remetallizers. We found some variations. However,
according to the specialists, we can neglect them (look the table). But we
think about the results more strict as we present customer interests as we
count the deviations as the remetallizers’ negative.
However, we
can compliment the products: the engine details go better with them.
It became clear when we checked the effectiveness of the products
on the “friction machines” CMT-1 and ÈÈ 5018 (look illustrations of the
tests results) – they imitate work of the weakest engine nodes: bearing
and piston rings. "Loading" the “friction machine” by the pure oil we
measure temperature, moment and friction coefficient between the details.
Then we repeated the tests. This time we only mixed remetallizers with the
oil proportion.
RESURS MOTO is
remetallizant, manufacturers recommend it to the engines with the separate
lubrication system.
|